cannot merge arduino templates in multisim

Import the schematic into the PCB editor.

Assign “footprints” to all the components.

Re-create the schematic in KiCad using the Schematic editor.

Create a new project – from a template if one exists (there are templates for Arduino and Raspberry Pi).

These are the basic steps in the workflow so far: Pretty much everyone I’ve spoken to uses KiCad (or an equivalent commercial tool), so I thought I’d take the plunge and see if I could give it a go. Fritzing has a PCB editing view and I have tinkered with it before, but I didn’t really know what I was doing. I’m attempting to reproduce the circuit from my Arduino Uno Dual Merge MIDI “Shield” into a PCB.

If you are new to Microcontrollers, see the Getting Started pages. Official Getting Started with KiCad 6.0.These are the key tutorials for the main concepts used in this project: Find the Build Guide for this here: Arduino Uno Dual Merge MIDI “Shield” – Part 3.I am not responsible for any damage to expensive instruments! Warning! I strongly recommend using old or second hand equipment for your experiments. I’ve not seen anything like my Arduino Uno Dual Merge MIDI “Shield” available anywhere but it is built of individual designs I am very familiar with, so I thought I’d give it a go. I’d like to add it to the list of things I’m amateurly enthusiastically ignorant about.

Two templates are attached below and another template can be found at Multisim MXP Daughter-board Templates for myRIO.I’ve been meaning to have a try at PCB design for a while. If using the enclosed NI myRIO the template is available on NI Labs details of which can be found at Multisim MXP Daughter-board Templates for myRIO. The templates for the board-only NI myRIO are installed with Multisim. Figure 7 shows an image of the schematic and layout for the Multisim NI myRIO Single MXP template.įigure 7 - The Multisim template for a Single MXP daughter board comprising of a Multisim schematic with the available IO and an Ultiboard layout with the connector and board outline. From here, in Multisim you can place the components you will be using and in Ultiboard you can create the layout of these components around the built in connector and outline. We also get a description and preview of the template design.Ĭlick Create and Multisim will open both the schematic and a Ultiboard layout which will form the template of our design. Within this dialog select installed templates and we can select either the NI myRIO Dual MXP or the NI myRIO Single MXP. This opens the New Design window as seen in figure 6. The process for using these is outlined below: Multisim comes installed with the NI myRIO single MXP and dual MXP templates. Templates for NI myRIO provide an inclusive Multisim schematic with the available inputs and outputs and an Ultiboard layout with the connectors and outline.

Cannot merge arduino templates in multisim